Engineered oak timber flooring in a living room

3 Ways To Keep Engineered Flooring Clean

Engineered timber flooring is an attractive alternative to solid hardwood. Its stability, and the range of species, stains and finishes available, make it a popular choice for Australian homes. Like all floors, though, it needs the right care to stay looking new. Here is how to clean engineered timber floors properly, and what to avoid.

1. Sweep or vacuum regularly

Grit is the main enemy of a timber finish: every piece of dirt walked over the floor acts like sandpaper. Sweep high-traffic areas daily with a soft broom or microfibre sweeper, which traps dust without scratching.

Vacuum weekly to pick up the fine particles sweeping misses, especially between planks. Switch the vacuum to its hard-floor setting so the beater bar or rotating brush is off.

2. Spot clean spills straight away

Blot spills immediately with a soft, dry cloth. If a mark remains, apply a small amount of a pH-neutral hardwood floor cleaner to the cloth (never directly to the floor) and wipe gently. The aim is to clean with as little moisture as possible.

Use a cleaner designed for engineered or hardwood floors. Avoid soap-based products, vinegar mixes and anything that leaves a residue, as they can dull the factory finish over time.

3. Schedule a regular deeper clean

Every few weeks, go over the floor with a well-wrung damp microfibre mop and a floor cleaner recommended by the flooring manufacturer. Work in sections and dry as you go so no standing water is left on the boards. Adjust the frequency to suit foot traffic, pets and how much dirt comes in from outside.

Engineered timber flooring dos and don'ts

Do

  • Use mats at entries and rugs in hallways and living areas to stop grit and wear before it reaches the boards.
  • Fit felt pads under chairs, tables and cabinets so they slide rather than scratch.
  • Clean up water, pet accidents and drinks immediately.
  • Keep indoor humidity reasonably stable. Engineered boards move less than solid timber, but big swings in humidity can still open gaps or cup the boards.
  • Keep pets' nails trimmed.

Don't

  • Use harsh, ammonia, bleach or wax-based cleaners, or abrasive pads.
  • Use a steam mop. Steam forces moisture into the top layer and can cause the layers to swell or delaminate, and it will usually void the warranty.
  • Use home-made polishes or vinegar and baking soda mixes; stick to pH-neutral products the manufacturer recommends.
  • Drag furniture or appliances across the floor.

If the floor eventually shows deep scratches or dullness, most engineered floors with a thick enough veneer can be professionally sanded and re-coated once or twice over their life. Check your product's specification before booking this.

Trust Mayne Rugs & Flooring for your flooring

A few minutes of care each week makes a real difference to how an engineered floor looks and how long it lasts. At Mayne Rugs & Flooring we supply and install engineered timber and oak, hybrid and laminate flooring across Sydney, and our installation guide covers the care requirements for each range.

Get in touch for product advice or to book a free measure and quote.